GR874-D20
Abstract: MIDISCO sliding
Text: VCO Application Notes AN-113 Pulling Measurement Of Z-COMM VCOs The pulling response of Z-COMM VCOs is directly affected by improper matching and insufficient isolation. The frequency variation due to load mismatching is defined as pulling. Measured pulling
|
Original
|
PDF
|
AN-113
AN-113
8563E
AN-102
GR874-D20
MIDISCO
sliding
|
Z-COMM
Abstract: SN96 SB35
Text: APPLICATION NOTE AN-107 MANUAL SOLDERING TECHNIQUE FOR Z-COMM VCOs This note describes common manufacturing methods used to solder Z-COMM surface mount and pin mount VCOs. Following the suggested practices will ensure optimum performance and repeated product reliability.
|
Original
|
PDF
|
AN-107
Z-COMM
SN96
SB35
|
Untitled
Abstract: No abstract text available
Text: A Dimensions: [mm] B Recommended land pattern: [mm] D Electrical Properties: Properties Test conditions Value Unit Tol. Impedance @ comm 25 MHz Z 20 Ω ±25% Impedance @ comm 100 MHz Z 30 Ω ±25% Impedance @ 2 turn 25 MHz Z 75 Ω ±25% Impedance @ 2 turn
|
Original
|
PDF
|
|
Untitled
Abstract: No abstract text available
Text: A Dimensions: [mm] B Recommended land pattern: [mm] D Electrical Properties: Properties Test conditions Value Unit Tol. Impedance @ comm 25 MHz Z 34 Ω ±25% Impedance @ comm 100 MHz Z 52 Ω ±25% Impedance @ 2 turn 25 MHz Z 136 Ω ±25% Impedance @ 2 turn
|
Original
|
PDF
|
|
Untitled
Abstract: No abstract text available
Text: A Dimensions: [mm] B Recommended land pattern: [mm] D Electrical Properties: Properties Test conditions Value Unit Tol. Impedance @ comm 25 MHz Z 20 Ω ±25% Impedance @ comm 100 MHz Z 30 Ω ±25% Impedance @ 2 turn 25 MHz Z 75 Ω ±25% Impedance @ 2 turn
|
Original
|
PDF
|
|
R04003
Abstract: R0-4003 AN-101
Text: APPLICATION NOTE AN-101 MOUNTING AND GROUNDING OF Z-COMM SURFACE MOUNT VCOs Z-Comm VCOs are available in several surface mount packages. The VCO ground plane should be in direct contact with the PCB ground plane which must consist of a conductor covering the full underside
|
Original
|
PDF
|
AN-101
Mini-16"
MINI-16
R04003
AN-102
AN-107
R0-4003
AN-101
|
411X
Abstract: ABP1 10MHZ AN-202 LMX2306
Text: Application Note AN-202 Programming Z-COMM Phase Locked Loops Nomenclature Z-COMM has three models of Phase Locked Loops available, each using either the National Semiconductor or the Analog Devices PLL synthesizer chip. PSNxxxxx: PSAxxxxx: PCAxxxxx: Phase Locked Loop, Standard Package 0.6” x 0.9” , National Semiconductor.
|
Original
|
PDF
|
AN-202
P10-12
24-bit
411X
ABP1
10MHZ
AN-202
LMX2306
|
electronic assembly tape
Abstract: EIA-481-2
Text: Application Note AN-111 MARKING ORIENTATION AND TAPE PLACEMENT OF Z-COMM VCOs The proper orientation of Z-COMM VCOs can be determined by a reference marker etched on the shield of the VCO. All text is laser marked on the shield of the VCO. This application note
|
Original
|
PDF
|
AN-111
EIA-481-2
electronic assembly tape
|
ro4003
Abstract: motherboard drawing AN-101
Text: Application Note AN-101 Mounting and Grounding of Z-Comm Surface Mount VCOs Z-COMM VCOs are available in several surface mount packages. The VCO ground plane should be in direct contact with the PCB ground plane which must consist of a conductor covering the full underside of
|
Original
|
PDF
|
AN-101
MINI-16"
MINI-16
RO4003
AN-102
AN-107
motherboard drawing
AN-101
|
EIA-481-2
Abstract: No abstract text available
Text: Application Note AN-111 Marking Orientation and Tape Placement of Z-COMM VCOs The proper orientation of Z-COMM VCOs can be determined by a reference marker etched on the shield of the VCO. All text is laser marked on the shield of the VCO. This application note shows the location of
|
Original
|
PDF
|
AN-111
EIA-481-2
|
V585ME06
Abstract: frequency multiplier in Mhz MSA-0986 vco wide AN-101 AN-110 HMC187MS8 Z-COMM
Text: VCO Application Notes AN-110 Low Cost, Extremely Wide Bandwidth VCO Design Using Multipliers And Z-COMM VCOs Many of Z-COMM’s higher frequency VCOs can be converted, by the use of multipliers, into an extremely wide band high frequency VCO at a low cost. For the following example, a 1000-2000 MHz
|
Original
|
PDF
|
AN-110
HMC187MS8.
AN-110
MSA-0986
V585ME06
HMC187MS8
V585ME
AN-101
AN-102
V585ME06
frequency multiplier in Mhz
MSA-0986
vco wide
AN-101
HMC187MS8
Z-COMM
|
sliding
Abstract: No abstract text available
Text: Application Note AN-113 Pulling Measurement of Z-COMM VCOs The pulling response of Z-COMM VCOs is directly affected by improper matching and insufficient isolation. The frequency variation due to load mismatching is defined as pulling. Measured pulling performance of ZCOMM VCOs can be verified using the pulling test setup and procedure described in the following.
|
Original
|
PDF
|
AN-113
AN-102
sliding
|
AN-101
Abstract: AN-110 HMC187MS8 V585ME06 MHz VCO vcos
Text: Application Note AN-110 Low Cost, Extremely Wide Bandwidth VCO Design Using Multipliers and Z-COMM VCOs Many of Z-COMM’s higher frequency VCOs can be converted, by the use of multipliers, into an extremely wide band high frequency VCO at a low cost. For the following example, a 1000-2000 MHz VCO will be
|
Original
|
PDF
|
AN-110
HMC187MS8.
AN-110
V585ME06
AN-101
AN-102
HMC187MS8
MHz VCO
vcos
|
microstripline
Abstract: RF Transistor Selection AN-101
Text: APPLICATION NOTE AN-102 PROPER OUTPUT LOADING OF Z-COMM VCOs Z-COMM VCOs are designed to operate with an output VSWR of less than 1.67:1 RL = 12.0 dB . To tolerate impedance mismatch introduced by loading device(s) (e.g. mixers, prescalars) some form of isolation is needed at the RF output. A 10 dB pad and buffer amplifier are recommended (Zout = 50Ω
|
Original
|
PDF
|
AN-102
AN-101
microstripline
RF Transistor Selection
|
|
|
JEDEC SMT reflow profile
Abstract: J-STD-020 SAC305 SAC305 SAC305 reflow JEDEC J-STD-020 SAC305 reflow profile reflow profile SAC305 solder paste SMT Process Z-Communications
Text: Application Note AN-112 Using Convection Ovens for Attaching Z-COMM VCOs Introduction: This application note is to provide a basic SMT process guideline for solder reflowing Z-Communications voltage-controlled oscillators. The data provided complies with JEDEC J-STD-020 specification for peak
|
Original
|
PDF
|
AN-112
J-STD-020
SAC305
AN-112
JEDEC SMT reflow profile
J-STD-020 SAC305
SAC305 reflow
JEDEC J-STD-020
SAC305 reflow profile
reflow profile
SAC305 solder paste
SMT Process
Z-Communications
|
pll vco 2000 -2200 MHz
Abstract: No abstract text available
Text: PSA2150AF-LF Rev A1 Fractional-N Phase-Locked Loop Surface Mount Module Applications Application Notes • Fixed Wireless • Satellite Communications • • AN-107: Manual Soldering Technique • AN-202: Programming Z-COMM PLLs Performance Specifications
|
Original
|
PDF
|
PSA2150AF-LF
ADF4156.
PLL-24S1-H
PLL-24S1
FRM-S-002
pll vco 2000 -2200 MHz
|
Untitled
Abstract: No abstract text available
Text: PSA2150AF-LF Rev A1 Fractional-N Phase-Locked Loop Surface Mount Module Applications Application Notes • Fixed Wireless • Satellite Communications • • AN-107: Manual Soldering Technique • AN-202: Programming Z-COMM PLLs Performance Specifications
|
Original
|
PDF
|
PSA2150AF-LF
AN-107:
AN-202:
PLL-24S1-H
PLL-24S1
FRM-S-002
|
ADF4156
Abstract: AN-202
Text: PSA2100AF-LF Rev A1 Fractional-N Phase-Locked Loop Surface Mount Module Applications Application Notes • Fixed Wireless • Point to multipoint • • AN-107: Manual Soldering Technique • AN-202: Programming Z-COMM PLLs Performance Specifications Min
|
Original
|
PDF
|
PSA2100AF-LF
AN-107:
AN-202:
PLL-24S-H
PLL-24S
FRM-S-002
ADF4156
AN-202
|
Untitled
Abstract: No abstract text available
Text: PSA1450F-LF Rev A1 Fractional-N Phase-Locked Loop Surface Mount Module Applications Application Notes • Fixed Wireless • Test Equipments • • AN-107: Manual Soldering Technique • AN-202: Programming Z-COMM PLLs Performance Specifications Min Frequency
|
Original
|
PDF
|
PSA1450F-LF
AN-107:
AN-202:
PLL-24S1-H
PLL-24S1
FRM-S-002
|
ADF4156
Abstract: AN-202
Text: PSA1450F-LF Rev A1 Fractional-N Phase-Locked Loop Surface Mount Module Applications Application Notes • Fixed Wireless • Test Equipments • • AN-107: Manual Soldering Technique • AN-202: Programming Z-COMM PLLs Performance Specifications Min Frequency
|
Original
|
PDF
|
PSA1450F-LF
AN-107:
AN-202:
PLL-24S1-H
PLL-24S1
FRM-S-002
ADF4156
AN-202
|
Untitled
Abstract: No abstract text available
Text: PSA2100AF-LF Rev A1 Fractional-N Phase-Locked Loop Surface Mount Module Applications Application Notes • Fixed Wireless • Point to multipoint • • AN-107: Manual Soldering Technique • AN-202: Programming Z-COMM PLLs Performance Specifications Min
|
Original
|
PDF
|
PSA2100AF-LF
Synthesi77
PLL-24S-H
PLL-24S
FRM-S-002
|
Untitled
Abstract: No abstract text available
Text: PSA2100AF-LF Rev A1 Fractional-N Phase-Locked Loop Surface Mount Module Applications Application Notes • Fixed Wireless • Point to multipoint • • AN-107: Manual Soldering Technique • AN-202: Programming Z-COMM PLLs Performance Specifications Min
|
Original
|
PDF
|
PSA2100AF-LF
AN-107:
AN-202:
PLL-24S-H
PLL-24S
FRM-S-002
|
mini circuits vco
Abstract: shunt resistor AN-117
Text: Application Note AN-117 Evaluation Board: MINIEVAL The MINIEVAL evaluation board can be used with Z-COMM VCOs in the MINI package. Model numbers are: VxxxMExx, VxxxMCxx, CLVxxxxx, CROxxxxx, and SLVxxxxx. The topology of the MINIEVAL was designed with simplicity in mind. Only the essential components
|
Original
|
PDF
|
AN-117
mini circuits vco
shunt resistor
AN-117
|
RCA-CA3039
Abstract: CA3039 CA3039T MONOLITHIC DIODE ARRAYS RCA CA3039 21aoi
Text: G E SOLID STATE 01 I e| 3Ö7SDÖ1 GOmSTt. 4 Arrays _ ;_ CA3039 T 'S ^ 'Z H Diode Array Six Matched Diodes on a Common Substrate Ultra-Fast Low -Capacitance Matched Diodes For Applications in Comm unications and Switching Systems Features:
|
OCR Scan
|
PDF
|
CA3039
RCA-CA3039
92CS-I5261
750ai
CA3039
SJCS-1526'
CA3039T
MONOLITHIC DIODE ARRAYS
RCA CA3039
21aoi
|
